NOTICE: help.openstreetmap.org is no longer in use from 1st March 2024. Please use the OpenStreetMap Community Forum

1
1

Hi everyone

I am trying to fix one of the motorway link roads in Wolverhampton M54 junction 2. Although all of the link roads around and into the i54 are showing allow vehicle access when you go onto the directions section it is not allowing any.

I have checked over it all and cannot seem to see a fix for it. If anyone has a fix it would be really appreciated as its adding on a 6 mile detour because it does not realise that the slip road exists

Many thanks

asked 25 Apr '19, 12:57

joshuaowen's gravatar image

joshuaowen
26113
accept rate: 0%


You have several ways with construction=trunk still on them, for example https://www.openstreetmap.org/way/261259510 . OSRM will refuse to route over any way with construction=* . Review all the ways and make sure this tag is removed.

Remember that most routing engines take a while to update and your changes will probably take at least a day to be reflected in route calculations, very possibly more.

permanent link

answered 25 Apr '19, 21:57

Richard's gravatar image

Richard ♦
30.9k44279412
accept rate: 18%

thank you so much for that i did not realise the construction tag was in there. These roads have been built for the last few years and suddenly stopped working on the routes a while back and we couldn't work out why!

the only section that did not have any construction on was the m54 slip road coming onto the i54 islands where the construction section was. I have changed all the rest of the construction. Fingers crossed this sortes the rest

Thank you again

(26 Apr '19, 07:56) joshuaowen

Overpass turbo finds these two nearby ways with construction tags still on them, though shouldn't be part of the M54 junction issue. https://www.openstreetmap.org/way/132669546 https://www.openstreetmap.org/way/132669539

https://overpass-turbo.eu/s/Ihw in case you want to check other areas

(26 Apr '19, 12:16) EdLoach ♦

Can you post the route you are trying to get working, and whether is is a problem on both Car (OSRM) and Car (GraphHopper)? GraphHopper seems happy with routes like https://www.openstreetmap.org/directions?engine=graphhopper_car&route=52.6383%2C-2.1427%3B52.6334%2C-2.1417#map=16/52.6356/-2.1387 and https://www.openstreetmap.org/directions?engine=graphhopper_car&route=52.6380%2C-2.1123%3B52.6334%2C-2.1417 (and their reversed versions, if you move the motorway pin across to the correct carriageway).

permanent link

answered 25 Apr '19, 15:32

EdLoach's gravatar image

EdLoach ♦
19.5k16156280
accept rate: 22%

It looks like the system we use runs off the OSRM as the route is working with Graph Hopper. Just looks like we need to work out a way of OSRM noticing the same motorway exit rather than going across to the next one

https://www.openstreetmap.org/directions?engine=fossgis_osrm_car&route=52.6815%2C-2.4073%3B52.6354%2C-2.1244#map=15/52.6346/-2.1494

this is the route that diverts to the next motorway junction to turn around. The reverse journey works correctly

https://www.openstreetmap.org/directions?engine=fossgis_osrm_car&route=52.63549%2C-2.13535%3B52.63056%2C-2.12791#map=16/52.6341/-2.1342

this is the other section that doesnt seem to work with OSRM. It stops the journey as it meets the A4510 rather than going down the road as it does work Graph Hopper

Cheers for the help

(25 Apr '19, 16:17) joshuaowen

This fails for OSRM because some highways still have a construction tag set, for example https://www.openstreetmap.org/way/645424831. The mapping is unclear. There is highway=primary and construction=trunk. Either the road is usable or it is in a construction state. OSRM decides to choose the latter case and avoids it. The map data needs to be fixed. See https://help.openstreetmap.org/questions/68719/how-do-i-fix-a-routing-error-of-1700km-osrm-vs-59m-graphhopper for the same discussion.

(26 Apr '19, 07:39) scai ♦

I removed one or two construction tags on those roads, but may have missed some.

(26 Apr '19, 11:57) SK53 ♦

Follow this question

By Email:

Once you sign in you will be able to subscribe for any updates here

By RSS:

Answers

Answers and Comments

Markdown Basics

  • *italic* or _italic_
  • **bold** or __bold__
  • link:[text](http://url.com/ "title")
  • image?![alt text](/path/img.jpg "title")
  • numbered list: 1. Foo 2. Bar
  • to add a line break simply add two spaces to where you would like the new line to be.
  • basic HTML tags are also supported

Question tags:

×535
×305
×43

question asked: 25 Apr '19, 12:57

question was seen: 2,051 times

last updated: 26 Apr '19, 12:16

NOTICE: help.openstreetmap.org is no longer in use from 1st March 2024. Please use the OpenStreetMap Community Forum