Hi, another technical question:

Bicycle parking spots are often on one side of the sidewalk. So when adding a node to mark the bike parking in the map, there are two options:

1) Set an individual node where the bike parking (often: bike stands) are, either using GPS or imagery. This node will not be connected to any ways or paths.

2) Put the node onto the footpath/sidewalk, since it is kind of part of it. I don't think this is a good idea, but would like to hear confirmation.

3) May be use a relation with 1)? Again, I doubt this is needed or any useful.

I have used option 1 so far, but would like to ask the community about the "best" approach.

Cheers, Steffen

asked 23 Mar '16, 14:15

rabon's gravatar image

rabon
1914512
accept rate: 0%


I do option 1 also. This is how car parking works too.

Modeling on how car parking gets extended, if you make the bike parking an area, you could connect that to a nearby path/highway.

permanent link

answered 23 Mar '16, 14:20

neuhausr's gravatar image

neuhausr
7.3k869120
accept rate: 21%

1

I agree with you, but I'd also add that if the node representing the bike parking was part of the way for the bike path it would seem like the bike parking was in the middle of the path. Presumably not the case.

(24 Mar '16, 23:30) keithonearth

I agree with keithonearth after considering about it. It should probably never be put onto a node, because otherwise that would mean that the path is blocked or interrupted by the parking. Which is ususally not the case.

(29 Mar '16, 16:27) rabon
1

I think following above discussion, the answer is quite clear, the bike stands shouldn't be put on nodes on a way. This thread can be closed.

(29 Mar '16, 16:29) rabon

You can mark the correct answer as the correct one - click on the "tick / checkmark" below the correct answer.

(29 Mar '16, 16:32) SomeoneElse ♦
Your answer
toggle preview

Follow this question

By Email:

Once you sign in you will be able to subscribe for any updates here

By RSS:

Answers

Answers and Comments

Markdown Basics

  • *italic* or _italic_
  • **bold** or __bold__
  • link:[text](http://url.com/ "title")
  • image?![alt text](/path/img.jpg "title")
  • numbered list: 1. Foo 2. Bar
  • to add a line break simply add two spaces to where you would like the new line to be.
  • basic HTML tags are also supported

Question tags:

×68
×52
×49
×7
×2

question asked: 23 Mar '16, 14:15

question was seen: 1,532 times

last updated: 29 Mar '16, 16:32

powered by OSQA